|
Inserting Inside Front
Wall. Reference detail in next photo. Make sure outside is smooth. |
Detail of Front Right
Corner showing how pieces fit together. Note also the angle of the Braces
as they go to the floor. |
Inner Bottom being
inserted, smooth side up. Then be sure Front and Rear End Braces are pushed
all the way under at the bottom, creating an angle. |
|
Optional Air Switch:
Screw Air Button Holder to inner left side of tank. Place bottom rear corner
of Air Button Holder 13" from the Bottom and 20" from the Rear. |
Optional Air Switch:
Remove Holder. Insert through The Wall Fitting into top Rear hole. |
Optional Air Switch:
Tape coiled end of Clear Tube to middle of area where screw holes have been
made. |
|
Optional Air Switch:
Insert Rubber Tube into hole in Black Cap. Insert Black Cap into the Through
The Wall Fitting. |
Optional Air Switch:
Connect Clear Tube to Black Rubber Tube with Elbow. Pull Black Rubber Tube
until Elbow is in Cap. |
Optional Air Switch:
This is the actual Air Switch. |
|
Heater Pad: Center
the Heater and put the cord out a lower Rear hole. Do not plug in Heater
before Tank is filled and salt dissolved. |
Place Black Formed Plastic Square in
the same Rear hole and thread cord through. In order to do this remove
inside Front piece temporarily to allow Rear wall to be lifted.
|
Temperature Control:
Place 2nd Black Formed Plastic in the other Rear bottom hole. Insert sensor
into groove. Do not plug in Temperature Control before Tank is filled and
salt dissolved. |
| |
|
|
